flexural strength

15 ℃ degrees of compressive flexural strength is the best.

15℃的抗压抗弯强度最佳。

Advanced technical ceramics. Monolithic ceramics. Mechanical properties at room temperature. Part 1: determination of flexural strength.

高技术陶瓷. 单片陶瓷. 室温下的机械特性. 第1部分: 抗弯强度的测定.

Advanced technical ceramics-Methods of testing monolithic ceramics-Thermomechanical properties-Part 1: determination of flexural strength at elevated temperatures.

高级工业陶瓷.整体陶瓷的试验方法.热机械特性. 第1部分: 高温下挠曲强度的测定.

The similar tendency was also found in the transverse flexural strength of the composites.

在侧向纤维方向的材料弯曲强度也可发现相同的趋势。

Cordierite ( MAS) and MAS/ SiC multiphase material were prepared, and then the multiphase material's bulk density, open porosity, flexural strength and thermal-shock resistance were measured.

合成堇青石（MAS）并制备MAS/SiC复相材料，测试了复相材料的体积密度、开口气孔率及抗热震性等。

The relationship between nucleation temperature and flexural strength was investigated.

研究表明:抗弯强度、晶相含量随温度的升高先提高然后有所下降.

Flexural strength and elasticity decreased significantly with increasing wood content.

4.含木率之增加降低了抗弯强度及抗弯弹性率至为显著.

The flexural strength and tensile strength slightly decreased.

复合材料的弯曲强度和拉伸强度稍有降低.

Study on Residual Flexural Strength of High-Performance Concrete at Elevated Temperature

高性能混凝土高温后残余抗折强度研究

The flexural strength and specific modulus were moderately high.

复合材料的弯曲强度和比模量较高；

Mechanical Significance of Post-peak Flexural Strength for Low Elastic Modulus Fiber Reinforced Concrete

低弹性模量纤维混凝土剩余弯曲强度的力学意义

Pultruded fiberglass is stronger, and has higher flexural strength than timber.

拉挤玻璃纤维是强, 具有较高的抗弯强度比木材.

The tensile strength, impact strength, flexural strength, thermal properties and morphology of the composites were investigated.

研究了复合材料的拉伸强度 、 冲击强度 、 弯曲强度 、 形态及热性能.

Flexural Strength of Steel Fibers Concrete Study on the Pavement

基于钢纤维混凝土铺装层抗折强度的试验研究

The experimental investigation of the flexural strength of denture base resin

义齿基托材料抗折强度的实验研究

The Practical Superposition Method for Flexural Strength Computation of the Reinforced Concrete Beam

钢骨混凝土梁正截面抗弯承载力计算的实用叠加法

The results generally indicate that the flexural strength of the repaired beams is increased, but the ultimate load of beams with tension delamination failure is reduced relatively.

试验结果表明，玻璃纤维布加固的钢筋混凝土梁抗弯承载力显著提高，发生剥离破坏的试验梁极限荷载相对地有所降低。

The flexural strength, relative dielectric constant and dielectric dissipation factor of the composite were measured.

测试了复合材料的断裂强度, 相对介电常数和介电损耗.

The material mechanical properties, such as flexural strength, are measured by three point bending techniques.

利用三点弯曲方法测定了材料的抗弯强度等力学性能.

A New Technique for Increasing Flexural Strength of Reinforced Concrete Beams with Continuous Carbon Fibre Sheet

应用碳纤维布增强钢筋混凝土梁受弯承载力新技术

Experimental study on the flexural strength of fine grain ethanol model ice

细粒酒精模型冰的弯曲强度试验研究

Study on preparation methods and mechanical properties of high flexural strength cement concrete with heavy vehicle

重载高抗折强度水泥混凝土的配制及其力学性能研究

Testing method for flexural strength of high performance ceramics

GB/T6569-1986工程陶瓷弯曲强度试验方法

Study on the flexural strength of 12 different non-metal core materials

12种非金属核材料的弯曲性能研究

The result is: The most important influence of ceramic is the flexural strength.

其中，陶瓷材料抗弹性能主要影响因素是强韧性，如抗弯强度。

Flexural Strength Design of Concrete Bridge Girders Strengthened by External Prestressing

混凝土桥体外预应力加固梁的抗弯强度设计

The flexural strength would also be decreased when molasses was added;

掺糖蜜后，抗折强度也有所下降；

Suitable amount of wood powder was also helpful for the increase of composite tensile modulus, flexural property and heat distortion temperature, while it might decrease the impact strength and tensile elongation.

适量木粉能提高复合材料的拉伸模量、弯曲性能和热变形温度，但材料的冲击强度和断裂伸长率有所降低。

For flexural strength test of cement specimen and other nonmetallic material.

用作水泥或其它非金属脆性材料试块的抗折强度测定.

Finite element analysis of gear flexural strength under UG background

UG环境下齿轮弯曲强度的有限元仿真